10/100/1000M 2-Port Fx + 4-Port Tx Fiber Media Converter Singlemode

Product Description

Technical parameters:
1. Standard Protocol: IEEE**2.3 *0 Base-T standard
  IEEE **2.3u **0Base-TX and IEEE**2.3zstandard
2. Connector: TwoUTP RJ**5 connector, twoSC/ST connector
3. Operation mode: full duplex mode or half duplex mode
4. Power supply parameter:
  Power line (External): ******5V AC; Power Adapter 5V 1A DC
5. Environmental temperature:**0 - *0
6. Relativehumidity: 5%**0%
8. TP cable: Cat5 UTP cable
9.Transfer fiber:
multi-mode: *0/**5, *2.5/**5 or **0/**0μm
single mode: 8.3/**5, 8.7/**5, 9/**5 or *0/**5μm
*0 Dimensions:
Power external:**5mm(L)x**2mm(W) x*5mm(H)
FCautions:
1. This product is suitable for indoorapplication.
2. Put on the dust cover of fiber interface when not used.
3. It is forbidden to stare at the TX fiber-transfer end with naked eyes.
4. Single optical fiber transceiver must be used in pair (See the attachment description in delivery).
FTrouble shooting:
1. Device is not matched. Please select the corresponding network device according to the transfer rate of the product (*0Mbps or **0Mbps,) when connected to other network devices (network card, hub, switch).
2. Line loss is excessive during the fiber wiring.Excessive loss in connector plug-in andfibersolderingwelding, and excessive intermediate nodes may cause excessive loss rate or abnormal operation.
FVLAN Function:
 

1. Support VLAN, QoS, IPv4, IPv6
2. Support long data up to *0K byte
3. Low consumption(5W), low temperature and good stability
4. Note: When the switch set at left side is VLAN Status, and