FOB Price
Get Latest Price|
1 Unit Minimum Order
Country:
South Korea
Model No:
EBR-D3012
FOB Price:
Place of Origin:
-
Price for Minimum Order:
-
Minimum Order Quantity:
1 Unit
Packaging Detail:
-
Delivery Time:
-
Supplying Ability:
-
Payment Type:
-
Product Group :
South Korea
Contact Person Kun
49-8 Chenonho Dong, Kangdong Gu, Other
Specification(Battery regenerator)
Input voltage/ Frequency : **0V ~ **0V ac / *0 ~
*0Hz (Depends on user’s
country.)
Output voltage : *2V dc (Also we have 6V and 8V
Restorer)
Range of Ah capacity : *0 Ah ~ **0Ah (other range can
be also provided by special order)
Power consumption : Maximum **0 Watts
Cable length of DC output : 1.5M for (+), (-)
each
Weight : *6Kg
Dimension : **0mm(H) x **0mm(W) x **0mm(D)
Lead Acid Battery
is a device that converts the chemical energy of electrolytes
into electrical energy by submerging two electrodes (+, -)
in electrolytes, and stores the electrical energy for later
use. The stored electrical energy can be used on demand
when necessary and it is called discharging. Electrolyte :
Diluted Sulfuric Acid *8%, Specific Gravity 1.**0
During the discharging cycle, sulfate(SO4) bonds with polarized
plates and its specific gravity decreases as it separates from
water. During the charging cycle, the bonded sulfate(SO4)
returns to electrolytes and its specific gravity increases again.
After batteries are used for prolonged period of time with
repeated charge and discharge cycles, anglesites (lead sulfate
crystals) can build up on the plates during the cycles.
Sulfates can combine with the plate or with other SO4’s to cover
the plate with layers, forming as an insulating membrane.
This built up layers of sulfate eventually cut off the passage of
electrochemical reactions and it is the status of battery dead so
to be discarded.
There are some other reasons that cause malfunction of battery
but above is the typical reason.
Battery worn out
In case of normal *2V SLI (Starting, Lighting and Ignition)
battery, the open circuit voltage measured by tester is around
*2.8V. And if the measured loading voltage is above
*0.8V, you might be able to start up the car engine with
satisfaction. If loading voltage of battery is *0.0V
~*0.2V, the car won't start up easily. If loading voltage of
battery is under *0.0V, it never start up the car, so it can be
regarded as dead battery. It is known to be unable to
restore the battery in case of the measured loading voltage is
under the *0.0V in common.
Other than SLI batteries such as deep cycle battery, UPS battery,
AGM battery etc. are basically also the same as SLI battery in
the way of restoration.
Specific feature of the reconditioning equipment (Battery
regenerator)
1. Alarm with safe protection when (+), (-) poles are
misconnected.
2. No electrical short when the DC (+), (-) clips are directly
conducted.
3. Voltage and current control function for optimistic
restoration.
4. Function of memory hold when sudden electrical failure or
accidental switch off occurs. (It maintains the status and time
so you can continue the restoration without restarting the
progress when the power returns.)
5. Fan cooling for inner temperature control of
Restorer.
6. Shuts off output power when Restorer is
overheated.
7. Automatic power cut off with ending signal at the
time of completion.
8. Announcement of bad battery with display when battery
cell is abnormal.
9. Function of full discharge during process.
*0. Provides reference time to figure out the battery
capacity.
Advantages
1. Simple operation.
2.Do not require lots of human power. (No chemical treatment
required.)
3. High frequency separates the sulfuric acid which had been
stuck in the cell plate thus hydrostatic level will
rise.
4. It will cause frequent follow of electric current.
5. High energy efficiency (Low power dissipation during
restoration process.)
6. Ability in restoration of discarded (dead) battery is
supremely higher than other battery charging or restoring
devices in the market. (But external damage, cell plate
deformation, lack of electrolyte will not be expected to be
recovered.)
7. When the machine detects the critical damage of the battery
during the restoration the machine stops restoration with
“CEL bad” display. This function saves time to achieve
more effective result.
Country: | South Korea |
Model No: | EBR-D3012 |
FOB Price: | Get Latest Price |
Place of Origin: | - |
Price for Minimum Order: | - |
Minimum Order Quantity: | 1 Unit |
Packaging Detail: | - |
Delivery Time: | - |
Supplying Ability: | - |
Payment Type: | - |
Product Group : | Battery Recondition |