Braiding around metal hoses

Product Description

Braiding around metal hoses
To increase pressure resistance, metal hoses can be equipped with one- or two-layer braiding. The braiding is firmly
connected to the hose fittings on both sides to absorb the longitudinal forces caused by internal pressure. Due to
its inherent flexibility, the braid moulds itself perfectly to the movement of the hose. Hose braiding consists of right-
and left-handed wrapped wire bundles that are alternately layered one over the other. This not only prevents hose
lengthening due to internal pressure, but also absorbs external tensile forces and protects the outside of the hose.
The basic material of the wire braid is usually the same as that of the corrugated hose. It is also possible to select
different materials in the interest of greater corrosion resistance or for economic considerations.
 
The braiding also greatly increases the resistance of the hose to internal pressure. The braid flexibly moulds itself to
the movement of the hose. This applies even if a second braiding is used, which further increases pressure
resistance. The method by which the braiding is attached to the connection fittings depends on the type of fitting
and the demands on the hose. Under rough operating conditions, an additional round wire coil can be wound over
the braid or the braid can be sheathed in a protective hose.
 
Functional principle of the metal braid
Wire braiding functions on the lazy tongs principle. When axial tension is applied to the hose, the braid reaches its
extension limit. This means that the wires lie tightly spaced with the smallest crossing angle, creating a hose
braiding of the smallest possible diameter and the largest possible length. When the hose is axially compressed, the
crossing angle and diameter increase to maximum values.
We love hearing from our customers and value your feedback.Here are ways to contact HOLA Co.,Ltd.*4 hours a day, 7 days a week.