Energy Efficient Lighting (Luxillum)

Product Description

Luxillum has provided an easy, convenient and affordable energy saving solution which provides energy savings of over *0% over the original power consumption. (benefits can reach up to *0% depending on application).

Luxillum E Tube Fluorescent Lighting is a revolution in the lighting industry which will enable the universally standard Fluorescent type light fitting (which has been manufactured unchanged using old technology for the past **0 years) to be upgraded to the latest *1 century technology with a simple tube replacement.

The new Luxillum Etube combines an inbuilt *1st century designed electronics control , a highly efficient T5 fluorescent tube and a high efficiency reflector in a simple fluorescent tube replacement.

Simply replace your old fluorescent light tubes with the “new” E Tube and immediately receive the benefits.

• Power Consumption
• Greenhouse Gas Emissions
• Power Costs
• Maintenance Costs
• Waste materials – mercury disposal!!

Other benefits (but not so obvious) of the Luxillum E Tube Fluorescent Lighting include;

• Extended lamp and control gear life
• Reduced waste mercury
• Reduced maintenance costs
• Reduced air-conditioning capacity requirements
• Meaning still lower power costs and less green house gases

Cost savings in utilsing the Luxillum E Tube Fluorescent Lighting can be significant. On current installations both in Australia and Taiwan the average reduction in power consumption is around *0%. This represents a saving of $**0 EVERY $***0 spent on lighting electricity bills. Savings on lower Air conditioning running costs would be additional to these savings.

• Built in electronic ballasts
• Same original sizes of the T8 fixture
• Attached to the replacement T5 tube
• T5 manufactured with effective light transmittance glass
• It fits in the original light fitting, with out requiring any modification and  provides an instant increase in brightness and efficiency

• Simply remove the original fluorescent tube and starter from the fitting
• Now fit the Etube adapter into the tube slot
• The original magnetic ballast works as a filter and increases the electronic ballast's power factor
• Presto ! in *0 seconds you have doubled the efficiency of the old light fittings and increased the light output to boot !!