GGD LOW VOLTAGE ELECTRIC PANEL

Product Description

1、The cabinet adopts the form of general cabinet and the frame is formed by partial welding and assembly of 8MF cold-bending section steel, the parts of the general cabinet are designed according to the principle of modules, and there are *0 die mounting holes, In the design of the cabinet, the heat dissipation problem in the cabinet operation is fully considered.The upper and lower ends of the cabinet body all have different Numbers of heat sink holes, when the electrical components in the cabinet heat, heat rise, through the upper end slot discharge, and the cold wind constantly from the lower end control supplement into the cabinet, so that the sealed cabinet body from bottom to top to form a natural ventilation duct, to achieve the purpose of heat dissipation.

3、The instrument door with electrical components is connected with the frame with soft copper wire and the mounting parts in the cabinet and the frame with knurled screws. The whole cabinet constitutes a complete grounding protection circuit

4、After the surface treatment of the cabinet and the panel, the internal components such as epoxy powder electrostatic spraying coating, uniform adhesion, strong corrosion resistance mounting bracket, etc. are galvanized

1、The elevation of the installation site shall not exceed ***0m

2、The ambient medium temperature should not be higher than **0℃ or lower than *5℃, and the average temperature for *4h should not be higher than **5℃

3、Indoor relative humidity not exceeding *0%(temperature: *5℃)

4、No conductive dust with enough to corrode the metal and destroy the insulation of the gas site

5、No fire and explosion hazard

6、No violent vibration and turbulence, and the vertical inclination of the site does not exceed 5°

7、If there are special conditions of use, please inform the manufacturer when ordering