Load Cell (ELC-S)

Product Description

A load cell is a transducer that is used to convert a force into electrical signal. This conversion is indirect and happens in two stages. Through a mechanical arrangement, the force being sensed deforms a strain gauge. The strain gauge measures the deformation (strain) as an electrical signal, because the strain changes the effective electrical resistance of the wire. A load cell usually consists of four strain gauges in a Wheatstone bridge configuration. Load cells of one strain gauge (quarter bridge) or two strain gauges (half bridge) are also available.[citation needed] The electrical signal output is typically in the order of a few millivolts and requires amplification by an instrumentation amplifier before it can be used. The output of the transducer is plugged into an algorithm to calculate the force applied to the transducer.

Main Technical Parameters
Item Value Remark
Model ELC-S (add measurement range)
Standard Capacity 0.5, 1, 1.5, 2, 2.5, 3, 3, 5, 4.5, 5, *0, *5, *0, *0 T (1T=***0kg)
Accuracy 0.*2% F. S.
Output Sensitivity 2.5mV/V
Non-Linearity 0.*2% F. S.
Hysteresis 0.*2% F. S.
Repeatability 0.*1% F. S.
Creep 0.*2% F. S. *0min. (**0° C~**0° C)
Input Resistance **0ohm ± *0ohm
Output Resistance **0ohm ± *0ohm
Insulation Resistance >***0M ohm (DC*0V)
Zero Balance 1.0% F. S.
Temperature Effect on Output Sensitivity 0.*2% F. S. /*0° C
Temperature Effect on Zero Balance 0.*2% F. S. /*0° C
Temperature Compensation Range **0° C~**0° C
Ambient temperature **5° C~**5° C
Excitation Voltage DC9~*2V Recommended
Max. Excitation Voltage Range DC6~*8V
Safe Overload **0% F. S.
Encapsulation IP*7
Cable Length 1 meter shielded *-wire cable Cable length can be customized
Materials Stainless Steel Or Steel Alloy
Load Cell of other shape are also available upon your specific enquiry.