PDH equipment with 16E1

Product Description

FAT**0E PDH Equipment is point-to-point transmission equipment operating at **0Mb/s bit rate compatible with existing plesiochronous systems. It adopts 1U high standard *9" rack. It is composed of 1*1 optical interfaces, *6 E1 interfaces, 3 ETH interfaces and 1 SFP **0M optical ETH interface, 1 EOW interface, 1 RS**2 interface, and 1 ETH NMS interface. . 

FAT**0E PDH Equipment supports ETH management; it can manage the PDH equipment through the whole WAN network. Alarms, performance monitor, and parameters setting are available through the ETH NMS interface. 

The equipment is featured by very compact, minimum cost and low power consumption. It is ideal for application areas such as remote transmission in point-to-point links with small capacity and LAN extension.

 

Features

* Networking ability, can build up PDH network through the WAN network;

*  ETH NMS management, user can manage all the PDH equipment through WAN network; 

*  Alarms, performance monitor, and information about the local/remote equipment status are available;

*  Optical interface: **0Mb/s, *0Km transmission without repeater;

* 1*1 optical interface protection 

*  Provides *6 E1s comply with ITU-T G.**3 on interface and G.**2, G.**3 on jitter performance; Local/Remote loopback is supported; 

* 4 ETH interfaces, herein 3 *0/**0M ETH interfaces and 1 **0BASE/FX SFP optical ETH interface, supports special VLAN, VLAN, broadcast protection, and enable or disable the ETH interface;

*  Provides Engineering Order Wire (EOW), ETH NMS interface and RS**2 interface (NMS) for equipment management

*  Both AC **0 and DC**8 are available

*  Single board design, 1U high, and *9 Inch wide