powder blowback control board

Product Description

Blowback line 6, 8, *2, *8, *4 point output circuit boards.

 Characteristics of the equipment: automatic control; Scope: powder spray booth equipment; Rated voltage (V): **0V

Uses for the powder room equipment automatic blowback, median, cheer time

Equipment features automatic control

Electrical parameters:

1 Operating voltage: AC**0V *0HZ

2 Operating Current: less than *0mA

Blowback time :0.**6 seconds (adjustable)

Interval: *****0 seconds (adjustable)

 Nickname :: pulse cleaning plate blowback control panel

 Blowback circuit board is an intermittent cycle program controller for the powder room recycling machine automatic blowback ,****-digit adjustable boost the morale of the time, between continuously adjustable interval. Used in powder spray booths, dust collector, blowback airflow control pulse valve, pulse valve backflush set time. The blowback PCB Features: automatic control; Use: recycling machine for powder room automatically blowback, the median the cheer time interval adjustable controlled solenoid valve number :***6 (can be set), rated Voltage: AC**0V (**0% ~~ **0%) *0HZ**0HZ

 Rated output voltage: AC**0V (or other specifications), rated output current: 1A

 Blowback control panel instructions for use
 

 Time adjustment: press the Settings in the running light interval indicator light, at the same time intervals digit flashes, press the adjustment single-digit adjusted interval (**9), adjusting good single digits and press Settings , the time interval ten-digit flashes, press the control to the interval ten-digit adjustment (**9), the longest interval of *9S, adjust the interval time set is pressed, the backflush indicator light blowback time flashes, press the adjustment s to adjust the backflush time (1S units, the maximum time for 9S the usual majority 2S), set up to save the Settings to exit.
 

 Blowback median adjustments: run light Press adjustment , and then press the Set until the the median indicator light, release the , then set digit digital display, according to regulator to adjust the desired control digit (8 plates **8, *6 boards, such as setting ***6 to **5, 5 cycle output), the adjustment is completed, press the Settings to exit save.
 

 Wiring method: L-phase line into the line, the N zero line into the line, N1 is the common line (*6 plate 2), 8 plates **8 for output phase line, *6 plate ***6 for the output phase line.