Ruijin special double-sided Sticky insect board, insect luring board, yellow, blue and green board, greenhouse, tea garden

Product Description

No matter the yellow board or the blue board: the hanging height is very important when trapping. When the plant is in the seedling, the hanging height should be ****5cm higher than the seedling. When the plant height is close to the trap plate, it should be ****5cm higher with the plant height. If the height of the high-stalk crop is 0.**1 m, the trap board should be hung between the rows, and the height should be the same as that of the crop. This is beneficial to close to plants and more effectively trap pests. There is also an immediate method of catching insects. When the plant is tall and luxuriant, and there are many pests, several insect traps can be used to connect together. People stand between the rows of the plant, one hand the insect trap, the other hand the small wooden stick to vibrate the plant, while vibrating, while walking, you can see that small pests like whitefly rush to the insect trap in one direction like smoke, and the insect trap is filled with countless pests in a few minutes, you can change a new insect trap and repeat!
Reuse
The insect trap plate covered with small insects can be washed with clean ball and water for **2 times, and it is not necessary to apply shellac. Continue to use.
(3) Old armyworm board, glued, painted and used repeatedly
We have a special small package of shellac for end users, which can be used repeatedly. The insect trap glue in a **0g vial can be coated with ****0 pieces of *5x*5cm insect plate (double-sided). The method of gluing is very simple. Without special tools, take two insect plates with two hands, one with one hand, take about 2.5 grams of shellac, and spread it evenly on the insect plate. Then use both hands to close the two insect plates together, and then slowly separate and close them. The shellac will stick evenly after a few times of closing. Then, open and close the A side of the insect plate to the B side of the other plate with glue. Finally, face the A side of the B insect plate to the B side of the A raw plate, and separate and close it several times, There is glue on all sides of the two worm boards.