Wireless Transceiver nRF24L01 RF Wireless Module PB

Product Description

Transceiver nRF*4L*1 RF Embedded Board Module With Chip PB ***** use of the nRF***1 with wireless digital chip of Nordic Co 2.6 wireless device receiving supported 3. Transission rate:2Mbit/s 4.Working voltage ranges from 1.9V to 3.6V 5.5V tolerant 6.3uA Power down mode **0nA, stand-by mode 3uA ***** to be connected with low cost MCU This module allows the user to quickly evaluate the nRF*4L*1 from Nordic Semiconductor. Two 5 way 0.1" connectors bring out all the useful signals that can easily be plugged in to the most common prototype boards. This board will let you experiment with wireless COMMS quickly and easily. Matters need attention: The module power supply from 1.9V to 3.6V. Please put a LOW ESR capacitor of 0.1uF at the VCC pin. No circuit or component on board which is antenna covered so as not to influence the emission efficiency . The soldering temperature must be within **0 and no more than 3 seconds. If the communication port don't match the supplied voltage, please add a resistor of **0ohm at the communication port. The actual communication distance is related to the power quality, software design, environment condition .The communication distance can go above *0m normally.