Sell Power Plus Tile Dry Bond

Description

EXTRA-STRENGTH TILE DRY BOND Floor and Wall Thin-Set FOR INSTALLING ALL TYPES OF FLOOR AND WALL TILES. CERAMIC TILES, MOSAICS, PAVERS, QUARRY TILES Recommended for use on Concrete, Concrete Block, Gypsum Wallboard, Wonder board, Expended Styrene, Foam Insulation Board, Brick. HOW TO USE: Mix two volumes of POWER PLUS BOND with one volume of water the surface for the laying (concrete, mortar beds, bricks/block, masonry, marble masonry, marble ceramic tiles etc). No chipping is needed. Just spread POWER PLUS BOND mortar, place the tile (or marble, stone, brick, etc.) on the surface and grout in the normal way. Stickiness *0.4 kg/cm2 Pressure handle **1 kg/cm2 Chemical interference (acid, alkali, etc) 5.0 - 6.0 Thickness 3.6 mm Installation period after Spreading *0 – *0 min Installation period after ready mix 4 – 5 hours Consumption *0 kg is more than enough for *0m2 Ready time after Installation 8 hours. Tile wetness Not Required Sand Mixing Not Required Scratch the surface Not Required Scratching the old tiles Not Required Watering after installation Not Required Expert worker Not Required Contact Person: REHAN ANWER More Info: ***** ***** Cell Number: *0 *2 **4 ******3 Fax Number: *0 *2 *1 ******5