U-Pipe Solar Collector Water Heater

Description

U-pipe solar collector working principle: In each vacuum tube there is a U pipe with direct flow-through that is connected to the header pipe inside manifold. This U pipe is seamed in an aluminum heat transfer fin in the interior of vacuum tube that transmits the heat from the interior tube to the U pipe. Solar radiation permeates the outer glass tube and is captured on the outside of inner glass tube by highly selective sputter layer. The captured solar radiation is transmitted to flush-contact aluminum shield and then copper pipe filled with heat transfer fluid. The **0°aluminum heat transfer fin assures the fastest energy transfer. Each AKU is individually tested for leakage and other defects. anodized aluminum case and frame ensure no corrosion will happen to AKU collector. The AUCKLAT U pipe solar collector consists of 3 main components: 1. ALL glass vacuum tube 2. Heat transfer system(solar cycle) 3. Frame Advantages: ***** efficiency decrease during service life time ***** external pipe lines *****-side in-/outlet and hence only one roof penetration 4.Best possible insulation 5.Anodized aluminum casing and frame and anti corrosion 6.Angle adjustable frame 7.Pre-assembled unit and no tube assembling is necessary ***** for both flat roof and inclined roof 9.Pre-assembled packing