Sell Hydrostatic Pressure Testing Pumps and Equipments

Description

Hydrostatic pressure testing is a common procedure used to check fluid pressure vessel, such as, cylinders, boiler, tubes pipe, valves, castings, components etc. Hydrostatic pressure testing pump is also a common testing procedure to verify pressure vessels do not leak or have manufacturing flaws. Hydrostatic pressure testing pumps & equipments are important for pressure vessels in the interest of device safety, and durability under operating pressure. The pressure vessel to be tested is located within a sealed vessel. The sealed vessel is filled with an incompressible fluid, typically water or oil. The pressure test vessel is then subjected to a known internal pressure for a known duration. The known internal pressure is normally a significant percent greater than the maximum operating pressure of the device (typically **0%). The applied pressure causes the test vessel to expand, instrumentation, which is already in place, are then read to determine the total and permanent expansion that the test chamber (external) undergoes. A physical and visual inspection then follows the hydrostatic pressure test to determine that the device being tested has not been damaged or permanently distorted due to the test pressure. Pressure vessels may be re-verified by subjecting the vessel device to a proof-pressure test. The proof-pressure test is commonly referred to as a "modified hydrostatic test". The pressure vessel is subjected to a known pressure for a predetermined time. During and following the proof-pressure test, the pressure vessel is inspected for abnormal distortion or failure. PressureJet offers wide range of hydrostatic pump ranging from 1 lpm to **3 lpm and pressure up to ***0 bar. Hydraulic test pump is either electric motor driven or engine driven.