Sell Water Sandblasting

Description

Pressure Jet has achieved tremendous success on a new feature of Wet sandblasting application. more information visit at"pressurejet" website. There are variety of surface preparation methods available, such as solvent cleaning, power-tool cleaning, dry sand blasting etc. But, all these methods are rarely used because they are time consuming, not cost effective & provide poor results & also create pollution. Nowadays, water sandblasting by high pressure waterjet pump has got wide acceptance in the field of surface preparation as well as in paint removal & rust Removal. In wet sandblasting, an abrasive material is mixed with the waterjet to create an abrasive spray. This abrasive spray is blasted on the surface, which breaks away small pieces of undesirable coating corrosion or other undesirable substances to create the desired metal finish, perfect for recoating. Wet sandblasting is widely used in engineering, heavy engineering, fabrication, construction and many other industries for different applications. HOW WATER SANDBLASTING WORKS? Start the high pressure system and adjust the water flow and system pressure with your nozzle selection, pump RPM and Regulating Unloader setting. Open the trigger on gun to assure system is operating properly. Place the sand induction probe in the sand supply container. With the trigger on the gun open, adjust the small valve on the mixing head. The adjustment creates a vacuum in the sand hose line and starts the flow of sand. The pressure washer sandblaster should be approximately *2 to *5 inches away from the work surface when the trigger is opened and the water sandblasting operation begins. NOTE: Test a sample area to be certain that surface will not be damaged by abrasive action. The angle of attack and distance from the work surface may be varied to provide the best work speed, while still maintaining the greatest amount of impact energy. For optimum performance the sand inlet hose should not exceed *5 ft