Sell HM6005 HID compatible reader

Description

Wiring :
Red: Power ***6V
Black: Power ground
Green: Wiegand output D0
White: Wiegand output D1
Brown: Green LED control
Blue: Buzzer control
Yellow: Hold

Specification:

Dimension	*0 x *3 x *8mm
Power requirements	***6VDC at **0mA, A linear regulator is recommended
interface	wiegand
Reader range	***0cm
Frequency	******8KHz
Operation temperature	**0 C to **0 C
operationg humidity	5%**5% relative humidity non-condensing
Audio/Visual Indication	Green & Red and Buzzer signal output
Response Time	Less than 0.2 seconds
cable length	**0mm
Weight	**0gram

LED/Buzzer function description:
LED function: The LED color is normally in RED. It starts with 2 green flashes on
power up the reader and remains RED. When a RFID proximity card is present to the
reader, The LED will momentary flash green,this indicates that the card was read
properly by the reader. When the LED control signal is active, the LED changes to
green.

Beeper Function: Power up the reader, the beeper will active 2 times. When a RFID
proximity card is present to the reader, a short beep will be emitter. This
indicates that the card was read properly by the reader. When the Buzzer control
signal is active, the buzzer will sound till buzzer control line is released

Hold function: when this line is asserted,(made low by HOST) the reader will
buffer one card read (ignoring subsequent reads) until the line is released.(made
high or open)



?