Sell 250ml UV glue for crystal machine crystal UV glue

Description

**0ml UV glue for crystal machine crystal UV glue

crystal machine super glue

1.Features:Fast curing,high bonding strength,low viscosity permeable,easy to remove

air bubbles when sizing,suitable for large area bonding.Available manual and mechanical

coating,resistant to yellowing.

2.product usage:This product is suitable for glass and glass-to-metal bonding,can be used

for bonding glass,furniture,handicrafts,etc.

3.product appearance:Colorless or light yellow transparent liquid Viscosity(*5 degrees NDJ*1 viscometer,mPa.s):**0~***0 Curing time(S):*0~*0 Shear strength (MPa):glass/stainless

steel≥*0 broken glass

4.method of application:Before coating the adhesive surface to be dust,oil,dried(glass surfaces

should be removed with an organic solvent such as acetone water film),according to the need to determine the amount of adhesive (not too much).James finished glue together and bonding

surface,so that the glue slightly with the beat evenly and emit bubbles,a high-pressure mercury

lamp with *0mw/cm2 *0~*0s can be cured.If the first high-power high-pressure mercury lamp

positioning it **5 seconds,and then use a low-power high-pressure mercury lamp for about 5

minutes would be better.

Notes:1.This product is a slight skin and eye irritation,if accidentally splashed into the eyes,rinse immediately with plenty of water,as there does not need to go to the hospital for examination;skin

contact immediately with soap and plenty of water.

2.Use the rest of the glue not fall back to the original packaging in order to avoid contamination,

I sealed plastic dark at room temperature.

3.Do not allow children.

special annotation:

This glue does not matter no UV light,sunlight can be cured,usually in three to five minutes under the sun(This glue is to absorb the sun\'s ultraviolet curing chemical reaction,suitable for coffee table maintenance and production,maintenance and production of glass products,factory mass production,

we recommend using Henkel Loctite LPD***6),can be cured,the surface to be cleaned, laminating, when pressed,the smaller the gap,the higher strength after curing,and the bubbles should not produce; positioning must be accurate because the fixed time soon,or crooked very troublesome,glue easy,

would like to take down hard;sizing when the proposed drop in aluminum bread,glass bead will

naturally stretched to;around excess glue wipe clean.If you are unsure operational processes,

goods within the business cards,feel free to call the store Mobile Phone detailed consultation.

Annoyance:aluminum pie with residual glue how to remove the hard hand of fear zoned to scratch

the glass ugly,try this UV adhesive glue solution,painted in the curing of the glue point,about five

minutes the way to soften the glue,you can use the knife and removed.

Furniture workshop production of small batch production, it is recommended to use a dedicated shadowless lamp series.