Zhangjiagang Xiecheng Mechanical Equipments Co., Ltd.

CJMFH ***0 / ****-II: 1) Advantages: a) High speed of finishing products: reaches **5m/min because it's not subjected to the PE extruding machine's control, thus its cost for each square is comparatively low b) High yield rate, because all the unqualified goods can be reproduced until it's qualified 2) Disadvantage: high cost in warming up the extruding machine and rolling up the PE plates These two kinds of lines are the same from the preset macromolecule film to the finished products plat. They are automatic to set the PE plate of certain strength to the preset annulus to make the film combined with the plate. Then this combined material will be sent to be combined with the pre-warmed aluminum roll. After several times' combination and level off, and if it's molded, it's then sent to the cool oven for cooling. Then the cooled plat will be covered by a protecting coat and sent to the trimming machine then cut according to the customer's requirements. Considering of the above advantages and disadvantages, we recommend the customer to analyze his own condition and the benefits so as to choose the proper style of this machine. On the other hand, our company is capable of designing new machines according to customers' requirements.