Tapered Chisel Bits

Product Description

(1) Type: chisel bits
(2) Size: *9mm, *2mm, *5mm
(3) Diameter: *****0mm.
(4) Taper degree: 4°*6′, 6°, 7°, *1°, *2°
(5) Dimension of Tungsten Carbide：*5**0mm（Normal），*8**0（Strengthen）
(6) Skirt：Normal，Lengthen
(7) Package: in wooden case or in carton.
(8) Productivity: ****0pcs/ month

Advantages of taper chisel bits: cheap in price and the Assorted taper drill rods and rock drills, easy to carry and adequate for various construction conditions. Matched with taper drill rods, the taper chisel bits are widely used in drilling holes with depth less than 5 meters and diameter ranged in ****6 mm by light-duty rock drill. 
Each of rock drill bit is produced in different sizes and designs in order to optimize their application to a broader scope of rock drilling conditions and correspond to different job requirements. 
There are different taper degrees for taper drill bits which are used for different rock formations and rock drills.
Taper degree of *1°and *2°are common on modern rigs. A narrow taper degree of 7°is used for low impact rock drills and softer rock formations. This degree can also be used if you have spinning problems when using *1°or *2°equipment.
To ensure the normal service life, the taper drill bits need to be matched well with taper drill rods, the taper degree must be the same between taper drill bits and taper dill rods ; the penetration depth of taper drill rods which into the taper hole of taper dill bits should be over *5mm，and the head of the taper drill rods should not touch the bottom of the taper of taper drill bits, otherwise the taper drill bits would be lost easily during operation. 
The operation for rock drill is also important: before starting drilling, turn down the air flow level of rock drill to reduce the damage to the taper bits which is resulted from the local high stress suffered by the tungsten carbide. The taper bits should fully penetrated into rocks before turnning up the air flow back to the normal level, 
When the width of the edge’s flat top is more than 3 mm,It is necessary to change or grind the taper chisel bits in order to avoid low drilling speed and short service life of taper drill bits. Once there is abrasion for the taper on chisel drill bits, change or grind the chisel drill bits timely, otherwise the taper drill bits would be seriously worn, drilling speed would be lowered and the taper drill bits would even jammed.
Once encountering a steel bar or other foreign materials during rock drilling, the drilling position should be adjusted to avoid breakage of the head of rock bits.
When the rock drilling is prone to jamming, the rock bits should be replaced to taper cross drill bits or taper bits.