Ultimate Nano Coat v3

• Type: Other
• Place of Origin: Japan
• Brand Name:Max Protect
• Model Number: UNC v3
• Use:Nano coating liquid for DIY&PRO
• Expiration Date: 3 years shelf life
• Consumption: 3 ml per sqm
• Full curing time: *8 Hrs
• Heat resistance:(**0) - 1,**0 degrees celcius
• Product Size: *0 ml

ltimate Nano Coat v3 is from the same series as the UNC v1 and UNC v2, but is slightly modified to perform best on bare metal.

Like UNC v1 and UNC v2, Ultimate Nano Coat v3 is a permanent coating with extreme durability, heat resistant, ultra high resistance to chemical attacks and anti-rust properties - perfect for exhaust tips, polished aluminium alloy wheels,
chrome, engine parts, etc.

• Restores metal brightness Consumption: *0 ml. per sqm in two layers (7.5 ml. for the first & 2.5 ml. for the second)
• Heat resistance *******0 c
• Ultra-high resistance to chemical attacks (Bird poo, bugs, acid rain, heavy detergents, etc.)
• Oil, water and dirt repellent
• Anti-rust
• Not affected by suns UV or IR damage
• Strong UV filters built in
• VOC free
• **0% Inorganic
• Full curing time: *8 hrs.
• Room temperature curing

For extreme conditions: multi layering is possibleBefore UNC V3 application, please make sure the bare metal surface is polished and cleaned with Panel wiper/IPA.

Important:

It’s very important to have good lighting in the place of application! In dim light you might not spot smears left behind and removing them later will be a lot more difficult. Also, good ventilation will be necessary for health and safety regulations.

Please make sure you have the following before UNC v3 application:

1. Panel Wiper/ IPA – not supplied

2. Ultimate Nano Coat v3

3. Applicator Sponge – not supplied

4. Microfiber Towels – not supplied

UNC v3 Application:

Once again make sure the surface is cleaned with Panel wiper or IPA
before coating application. Clean the surface thoroughly with a fresh
microfiber towel and make sure there are no visible marks on the metal
surface before commencing the coating application.

1. Open the UNC v3 bottle and put the applicator sponge on top and
shake it once. Move the sponge a bit and shake it again. Do it for **4
times till the sponge is a bit wet (not soaked!).

2. Put the sponge on the surface and apply the coating with short and quick movements.

Don’t do circular movements. Keep applying till the whole area is covered.

3. At temperatures of less than *5c leave the coating for less than 3
minutes before removal. At higher temperatures remove the coating almost
immediately after applying.

4. Remove the coating with a microfiber towel cloth till smear free. We
recommend using 2 towels/cloths for excess coating removal.

5. For extra durability we recommend applying a second layer. Second
layer is to be applied **3 hours after the first one. The hotter the
sooner.

Tips:

1. Always use new microfiber towels/cloths

2. The coating crystallizes around the bottle necks, so take extra care when opening bottles for the first time.

3. Remember not to mix applicator sponges and other towels if other coatings are applied simultaneously.

4. Pay attention: once the sponges are dried, the liquid get crystalized and sponges couldn’t be re-used.

5. Recommended consumption is *0 ml. per sqm in 2 layers: ~7.5 ml. for the first layer and ~2.5 ml. per sqm for the second.

For more information please send your inquiry: max-protect.co.uk
Join Max Protect world chain of distributors today!