Adhesive Plaster

It is a gypsum-based adhesive mortar which can be used to bond gypsumboard, insulation panels etc. construction materials for interior sites.

• High durability and adhesion strength.
• A1 class non-combustible material.

It can apply to brick, concrete, gas concrete, briquet etc. surfaces

• Ambient temperature must be at least +5oC.

• Sections should be closed which causes air-flow.

· Dry and hot surfaces should be wetted.

· Surfaces should be cleaned from subtances (dust, dirt, oil, paint, etc.) which are preventing adhesion of plaster.

· Atışkan Betontak Plaster Primer should be used to improve adhesion on ceilings, smooth and absorbent surface applications.

· Fill fresh water into a clean container according to amount of mixture will prepared, approx. 5lt Water / 10kg Atışkan Adhesive Plaster sprinkles to cover the surface of water.

· After waiting for 2 minutes, slurry is stirred until it becomes homogeneous.

· The mixture is ready to be used within 30 minutes.

· Ready mixture should be apply at fist size with 25cm gap, starts from corner to cover boards bonding surface.

· Boards should be pressed to the surface with a straight-edge and spirit level should be checked.

· Do not add any other material (lime, sand, etc.) into mixture.

· The bonding surfaces should not be exposed to moisture and water.

· Avoid contact with skin and eyes. In case of contact wash with plenty of water.

Do not use any place except where application areas noted.

6 months for storage in closed bag and humidity proof conditions.