Hand Plaster

It is a gypsum-based mortar with perlite which can be apply between 5-20mm thickness onto interior walls and ceilings by hand.

• Stabilize ambient humidity.
• Helps heat and sound insulation.
• A1 class non-combustible material.

It can apply to brick, concrete, gas concrete, briquet etc. surfaces.

• Ambient temperature must be at least +5oC.

• Sections should be closed which causes air-flow.

· Fractures, cracks and defects should be corrected on surface.

· Dry and hot surfaces should be wetted.

· Surfaces should be cleaned from subtances (dust, dirt, oil, paint, etc.) which are preventing adhesion of plaster.

· Atiskan Betontak Plaster Primer should be used to improve adhesion on ceilings, smooth and absorbent surface applications.

· Fill fresh water into a clean container according to amount of mixture will prepared, approx. 6lt Water / 10kg Atışkan Hand Plaster sprinkles to cover the surface of water.

· After waiting for 2 minutes, slurry is stirred until it becomes homogeneous.

· The mixture is ready to be used within 60minutes.

· Metal bears should be used on walls to get the best result without wastage.

· Ready plaster can apply between metal bears using hand hawk and steel trowel. Levelling off the plaster with a metal straight-edge obtains a smooth surface.

· Do not add any other material (lime, sand, etc.) into mixture.

· Avoid contact with skin and eyes. In case of contact wash with plenty of water.

Do not use any place except where application areas noted.

10kg/m2 Atışkan Hand Plaster for each 1cm thickness.

6 months for storage in closed bag and humidity proof conditions.